![]() ![]() The maximum load capacity for this kit is 75 lbs., and it fits most bottom-mount drawer systems. They feature a self-closing design that commences at the final 2-1/2 in. No more guesswork when it comes to aligning drawer slides.These drawer slide kits are constructed of steel tracks with plastic rollers and come in a white powder-coated finish. This method worked perfectly with the DIY nightstand we built. Insert the drawer into the box and you are ready to add the drawer front or drawer face and finish up your build! Set the drawer on top of the plywood, extend out the drawer slides, and screw into place aligned with the front of the drawer.įinally, pull the plywood out. Now that the slide is secure in the drawer box, slide the plywood out so that it extends off the edge of the box. You can drill pilot holes before drilling in the screws, but I didn’t have any issues with cracking or splintering without them. Then, set your slide on top of the plywood and line it up (closed) with the front of the drawer box.Įxtend the drawer slide and then screw into place in the appropriate places on the side of the drawers. To install the drawer slides, place a strip of 1/4″ thick plywood on the bottom of your drawer box along each side. ![]() This allows for 1/2″ on each side for the side mount drawer slides to fit into. The width of your drawer usually needs to be 1″ shorter than the inside with of your drawer box. Start by building your drawer box and the drawer itself. Steps to install drawer slides without a jig:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |